Many times you have shown interest in how to extend and repeat your router's WiFi signal throughout your home or office without having to make a large investment, and having an acceptable signal and coverage. Well, the solution is simple: use a universal WiFi repeater. One of them is the Alfa W610, which we will explain how to configure below.
Installing the Alfa w610 WiFi repeater is simple. You should place it in a location where you have acceptable wireless signal coverage, above -55 Dbm, which is about three to four bars on the signal strength icon of your Windows devices. Discover how to extend and repeat your WiFi signal!
Extend and repeat WiFi signal
We set up the network:
First, we'll configure our network card with static IP addresses to extend and repeat the Wi-Fi signal:
We assign an IP address within the range 192.168.1.2 to 254.
We entered the ALFA AIP-W610H to configure it as a universal repeater:
We access the following address via a web browser:
192.168.1.1
Username: admin
Password: admin
We access Operation Mode:
We select Gateway
Second step to extend and repeat the WiFi signal, very important, in Access Control We need to select Mode Client
Wireless Security:
Next, we will configure the security settings for the wireless network we want to replicate, adding the encryption type it uses, such as WEP, WPA2, or WPA-PSK
Once the security settings are configured, we’ll move on to selecting the network. Select “Site Survey” to scan for wireless networks. Once you’ve located the network you want to connect to, select it and click “Connect.”.
Important:
The signal level must be above 55; otherwise, you will experience intermittent connectivity, and both the browsing experience and the loading of web content will be very poor.
If the data has been entered correctly, a message «connection successful» will appear.»
Next, we will configure the TCP/IP protocols. Select TCP/IP settings, then LAN Interface.
We will assign our repeater a different address pool than the main access point, in this case:
The main access point has the address: 192.168.1.1; it is a router with wireless functionality.
The Alfa W610 repeater: 192.168.2.1
Subnet Mask: 255.255.0.0
Default gateway: 192.168.1.1, the address of your main router
DHCP: Disabled, only if your router has DHCP enabled (it usually has it activated)
WAN interface
WAN Access Type: DHCP Client
To configure the repeater's gain, go to "Advanced Settings"
To verify that the settings are correct, go to Status:
We make sure it's connected, with this we have connected the repeater to the access point, we are now repeating the signal!
We have the ALFA AIP-W610H configured as a repeater, having completed the Wi-Fi network installation in repeater mode. We have managed to extend and repeat the Wi-Fi signal!
You can also learn how to extend WiFi signal in dead spots, How to solve this problem?